Problem with I2CCmd()

Discussion about the ZBasic language including the System Library. If you're not sure where to post your message, do it here. However, do not make test posts here; that's the purpose of the Sandbox.
Post Reply
spamiam
Posts: 739
Joined: 13 November 2005, 6:39 AM

Post by spamiam »

Yep, ta messed up pointer would do it! I think I have done something similar about an infinite number of times.

Thanks for fixing it so fast. Now I can move ahead with more streamlined code!

-Tony
Top
spamiam
Posts: 739
Joined: 13 November 2005, 6:39 AM

Post by spamiam »

I installed the new VM into my beta ZX24 and it is working beautifully. I tried installing it into a different ZX24, and it APPEARS to go thru the update with all the flashing of the LED, and the dots on the computer screen. But when the ZX restarts, it tells me that I have V2.5.1 on the chip, and the I2CCmd() still fails. It appears that the VM is not getting updated even though it looks as if the update is working fine!

I will post this message as a new thread in the ZX24 area.

-Tony
Top
mikep
Posts: 796
Joined: 24 September 2005, 15:54 PM

Post by mikep »

dkinzer wrote:The source of the problem has been found and corrected. It was also confirmed that the problem is limited to mega32-based devices (i.e., those built using the original ZX code base). It appears to have been introduced between the v2.3.1 and v2.5.0 releases.
The ZX-24e ZVM works correctly as well.
Mike Perks
Top
Post Reply

Return to “ZBasic Language”