ZBasic Forum

I'm not sure if the download for the compiler worked, or if there is a problem somewhere else. I hit compile, and it tells me that it cannot read my file because it cannot find it, same thing when i hit go. My computer will not read the file extensions at all. Not sure if this is common or not. I'm used to using BasicX and I figured I'd give this chip a try, however, I have not been able to get it to download any programs to the chip. Thank you for the help.

Dan

LtDan80 wrote:I hit compile, and it tells me that it cannot read my file because it cannot find it, same thing when i hit go.

Does it indicate which file it cannot find? Tell us a little more about the steps that lead to the problem and the complete messages that are generated. Do you load a project? If so, what files are in it?

LtDan80 wrote:My computer will not read the file extensions at all.

I'm not sure what you mean here. What are you seeing that leads you to this conclusion?

What OS are you using (XP, Vista, etc.)?

I figured out the problem, I was doing file new, instead of project new. I was trying to use the file to run the program, it is working fine now. I will be working with this chip a lot for a senior graduation requirement. I'm sure you will be hearing back from me. I will also send the final report with sample code for different sensors and motors back. Thank you for the prompt response.

Dan