ZX-24a not responding to Identify Device on Option Menu

Jim Fouch · Post by **Jim Fouch** » 28 September 2006, 20:57 PM

I just started using the new ZX-24a and have not been able to get it to respond to the Identify Device command on the Option menu.

I can program it and it runs fine. I added the "Option TargetCPU ZX24a" to my program.

Any ideas? Is there something I need to set up in the IDE to tell it what device I'm using???

Jim Fouch · Post by **Jim Fouch** » 28 September 2006, 21:09 PM

I figured out why...

I had the "Log device output to Debug window" option turned off. I use COM1 to send data to another uController.