Verification error after code download???

Questions and discussion about the ZBasic IDE.
Post Reply
Chuck
Posts: 1
Joined: 15 February 2006, 20:35 PM

Verification error after code download???

Post by Chuck »

Just tried out my first ZX-24. Its installed in a known good BX-24 controller board. Bx-24 loads and verifies just fine but the following message appears when I try to download the same code, that complied on the ZX IDE correctly, into the ZX-24.

Downloading file "C:\PFiX Controls Documents\ZBasic Projects\test.zxb":
.........................................................................................
Download complete.
Verifying download:
..
Verification error, record 1.
Download verification failed.
ZBasic v1.1.2

Any suggestions would be appreciated.

Additional info: I did try a simple Debug.Print "Hello world" program and that also failed to verify.
dkinzer
Site Admin
Posts: 3120
Joined: 03 September 2005, 13:53 PM
Location: Portland, OR

Post by dkinzer »

Download verification failed.
This is an indication of either an incorrect connection or a defective device. Since you're using it in a known-good development board, that leaves the latter.

Although the devices are tested after assembly to verify their operation it It is possible for a component to fail causing the problem that you see.

Send an email to support@zbasic.net and we'll get it replaced as soon as possible.
- Don Kinzer
DrBASICStamp
Posts: 8
Joined: 06 March 2006, 23:19 PM
Location: London

Hello,

Post by DrBASICStamp »

I have been using Basic Stamp for many years,
I am having same trouble here,
"Download Verification failed",
what do i do???
mikep
Posts: 796
Joined: 24 September 2005, 15:54 PM

Post by mikep »

First of all double check your connections. Do you see a startup message from the ZBasic runtime on the console.

Another thing to try is to verify the ATN line. See chapter 7 and the -a flag on the ZLoad utility.
Mike Perks
DrBASICStamp
Posts: 8
Joined: 06 March 2006, 23:19 PM
Location: London

It's still not working...

Post by DrBASICStamp »

It's still not working perfectly,
sometimes it will work,
sometimes it will not work,
is there any way to make thing go away?
I can't find it in the manual
would you be more specific?

oh yes, i am in vegas right now for a exhibition...
top secret!
Attachments
IMG_6132.jpg
IMG_6132.jpg (113.55 KiB) Viewed 9559 times
mikep
Posts: 796
Joined: 24 September 2005, 15:54 PM

Post by mikep »

did you actually try to find it in the manual. The URL you need is http://www.zbasic.net/doc/ZBasicRef/ZBasicRef91.html.

Just think if you had a portable ZX you could try this out even though you are on the road in Las Vegas.
Mike Perks
Post Reply